Rothwell Audio MC1-H Moving Coil Step-Up Transformer

The MC1-H is a step-up transformer designed specifically for “high output” moving coil cartridges where the output voltage is significantly lower than a typical moving magnet cartridge (which is about 5mV). Cartridges in this Category Include: Denon DL-110 Denon DL-160 Benz Micro MC Silver Hana EH Hana SH Roksan Shiraz

Rothwell Audio Signature Two Moving Coil Phono Preamplifier

The Signature Two is an audiophile moving coil phonostage employing low-noise discrete transistor circuitry throughout - no op-amps or transformers - and offers variable gain and cartridge load impedance. The Signature Two's circuit is the culmination of over 25 years experience in the design and production of audiophile phonostages and is a four-stage design using discrete transistors operating in Class A. The first stage is a low-noise design with adjustable load impedance from 32 ohms to 1100 ohms and gain variable from 52dB to 72dB, load and gain being adjustable independently of each other. This allows a very wide range of low output moving coil cartridges to be handled with optimum performance.

Rothwell Audio Headspace II Moving Coil Headamp

The Headspace II is a moving coil headamp (also known as a pre-preamp) which does a similar job to a step-up transformer, i.e. raises the output of moving coil cartridges up to moving magnet level, but does so with transistors rather than transformers. The benefits of the transistor approach are the ability to set the gain and the load impedance independently, and the extremely wide bandwidth. The Headspace II has four gain settings and eight load settings so a very wide range of cartridges can be accommodated.Please Note: The Headspace II can be battery powered.

Rothwell Audio Rialto MM/MC Phono Preamplifier

The Rialto is a phono stage pre-amp compatible with both moving magnet and low output moving coil cartridges. Discrete transistor circuitry is used throughout for maximum fidelity and lowest noise, and audiophile polypropylene capacitors are used for both the RIAA equalisation and signal coupling.

Rothwell Audio MCX Moving Coil Step-Up Transformer

This step-up transformer uses the same high quality cores as used in the MCL, again supplied by Lundahl of Sweden, but features a lower turns ratio than the MCL to accommodate cartridges with higher outputs. The turns ratio of the MCX is 1:10, making it compatible with cartridges with outputs of up to 0.9mV, which includes models from Benz Micro, Clearaudio, Koetsu, Lyra and Van den Hul.

Rothwell Audio MCL Moving Coil Step-Up Transformer

The MCL is a step-up transformer designed to raise the output of moving coil cartridges up to a level compatible with moving magnet phono stages. It's purpose is not simply to allow moving coil cartridges to be used with moving magnet only phono stages (which most valve designs are, for example), but to allow moving coil cartridges the chance to realise their full potential.

Rothwell Audio MC1 Moving Coil Step-Up Transformer

The MC1 is a step-up transformer designed to raise the output of moving coil cartridges up to a level compatible with moving magnet phono stages. It's purpose is not simply to allow moving coil cartridges to be used with moving magnet only phono stages (which most valve designs are, for example), but to allow moving coil cartridges the chance to realise their full potential.